SCS CTE701 - Verification Tester for Continuous Workstation Monitors

Description
SCS CTE701 - Verification Tester for Continuous Workstation Monitors

• Eliminate downtime by verifying on-site that your continuous monitor is operating with tolerances
• Loads resistance, impedance and voltage signals onto SCS continuous monitors

The SCS CTE701 Workstation Monitor Checker verifies the proper operation of the SCS WS Aware Workstation Monitor, SCS Ground Master Equipment Ground Monitor, SCS Iron Man Plus Workstation Monitor and SCS Ground Man Plus Ground Monitor. The Workstation Monitor Checker simulates resistance, impedance and voltage signals so that you can see whether the response of your monitors complies with your specifications. It meets the ANSI/ESD S20.20 requirements for compliance verification of continuous monitors.

The Workstation Monitor Checker presents certain loads and signals to the monitor that simulate specific parameters of ground connections and wrist straps.

Use to perform periodic calibration testing of the following items:

• CTC061 WS Aware Monitor
• CTC062 WS Aware Monitor
• CTC065 Ground Master Monitor
• CTC331 Iron Man® Plus Monitor
• CTC334 Ground Man Plus Monitor
• CTC337 Wrist Strap and Ground Monitor
• 773 Wrist Strap and Ground Monitor

Includes:

• 1 Workstation Monitor Checker
• 1 9V Alkaline Battery
• 1 Ground Cable (banana to alligator clip)
• 1 3.5 mm Male to Male cable